Specifications for this product appear below.
Characteristics
| Item | Specifications | Conditions | |
|---|---|---|---|
| Electrical characteristics | Rated current | 0.5A/contact (Max. 10 A at total contacts) | |
| Rated voltage | 60V AC/DC | ||
| Breakdown voltage | 150V AC for 1 minute | Detection current: 1mA | |
| Insulation resistance | Min. 1,000Mohm (initial) | Using 500V DC megger | |
| Contact resistance | Max. 90mohm | Measured based on the HP4338B measurement method of JIS C 5402 | |
| Mechanical characteristics | Composite insertion force | Max. 0.981N {100gf}/contacts × contacts (initial) | |
| Composite removal force | Min. 0.0588N {6gf}/contacts × contacts | ||
| Holding force of terminal securing section. | Min. 0.981N {100gf}/contact | Measures the maximum load in the post axial direction until removal | |
| Environmental characteristics | Ambient temperature | -55°C to +85°C | No freezing at low temperatures |
| Soldering heat resistance | Max. peak temperature of 260°C | Infrared reflow soldering | |
| 300°C within 5 seconds 350°C within 3 seconds |
Soldering iron | ||
| Storage temperature | -55°C to +85°C (product only) -40°C to +50°C (emboss packing) |
No freezing at low temperatures | |
| Thermal shock resistance (header and socket mated) | 5 cycles,
|
Sequence 1. -550-3 °C, 30 min. 2. ~, Max.5 min. 3. 85+30 °C, 30 min. 4. ~, Max.5 min. |
|
| Humidity resistance (header and socket mated) | 120 hours,
|
Bath temperature 40±2°C, humidity 90 to 95% R.H. |
|
| Saltwater spray resistance (header and socket mated) | 24 hours,
|
Bath temperature 35±2°C, saltwater concentration 5±1% |
|
| H2S resistance (header and socket mated) | 48 hours,
|
Bath temperature 40±2°C, gas concentration 3±1 ppm, humidity 75 to 80% R.H. |
|
| Lifetime characteristics | Insertion and removal life | 50 times | Repeated insertion and removal speed of max. 200 times/hours |
| Unit weight | 20 contacts; Socket: 0.05g Header: 0.02g |
||
Material and surface treatment
| Part name | Material | Surface treatment |
|---|---|---|
| Molded portion | Heat-resistant resin(UL94V-0) | - |
| Contact/Post | Copper alloy | Contact portion: Ni plating on base, Au plating on surface Terminal portion: Ni plating on base, Au plating on surface (Except for front edge of terminal) However, the area adjacent to the terminal on Ni barrier models is exposed to Ni on base. |
