DP2 Pressure/Flow Sensors Specifications
Specifications for this product appear below.
| Type | Vacuum pressure | ||||
|---|---|---|---|---|---|
| -101 kPa type | |||||
| Standard | Light weight | Flat | IP67 | ||
| Model No. | Asia | DP2-20 | DP2-80 | - | DP2-60 |
| North America (Note 2) | DP2-20F(-P) | - | DP2-40N | DP2-60N | |
| Europe | - | - | DP2-40E | DP2-60E | |
| Type of pressure | Gauge pressure | ||||
| Rated pressure range | 0 to -101.3 kPa | ||||
| Set pressure range | 5.1 to -101.3 kPa | ||||
| Pressure withstandability | 490 kPa | ||||
| Applicable fluid | Non-corrosive gas | ||||
| Selectable units | kPa, kgf/cm2, bar, psi, mmHg, inHg | ||||
| Supply voltage | 12 to 24 V DC +10 /-15 % Ripple P-P 10 % or less | ||||
| Current consumption | 50 mA or less | ||||
| Comparative outputs (Comparative Output 1 Comparative Output 2) |
NPN open-collector transistor ・Maximum sink current: 100 mA PNP open-collector transistor ・Maximum source current: 100 mA |
||||
| Output modes | Equipped with 4 types of modes: hysteresis mode, window comparator mode, dual output mode, automatic sensitivity setting mode (selectable by key operation) | ||||
| Response time | 2.5 ms or less | ||||
| Analog voltage output | Output voltage: 1 to 5 V (over rated pressure range), Zero-point: within 1 V ± 5 % F.S. Span: within 4 V ± 5 % F.S., Linearity: within ±1 % F.S., Output impedance: 1 kΩ approx. |
||||
| Display | 3 1/2 digit red LED display (Sampling rate: 4 times/sec. approx.) | ||||
| Displayable pressure range | 5.1 to -101.3 kPa | ||||
| Analog bar display | LED bar display in steps of 10 % F.S. approx. | ||||
| Protection | Standard, Flat and Light weight types: IP40 (IEC), IP67 type: IP67 (IEC) |
||||
| Ambient temperature | -10 to +50 ℃ +14 to +122 ℉ (No dew condensation or icing allowed), Storage: -10 to +60 ℃ +14 to +140 ℉ |
||||
| Pressure port | Asia | Standard, Flat and IP67 types: Rc (PT) 1/8 female thread, Light weight type: M5 female thread |
|||
| North America | Standard type: NPTF 1/8 female thread, Flat and IP67 types: NPT 1/8 female thread |
||||
| Europe | Flat and IP67 types: G (PF) 1/8 female thread | ||||
| Material | Front case: ABS, Rear case: PPS (glass fi ber reinforced), Display surface: Acrylic Pressure port attachment: Die-cast zinc alloy [Light weight type: POM (glass fi ber reinforced), pressure port is brass (nickel plated)] Front cover (IP67 type only): Polycarbonate |
||||
| Net weight | Standard type: 95 g approx., Flat type: 120 g approx., IP67 type: 370 g approx., Light weight type: 70 g approx. |
||||
| Dimensions | DP2-20□ : W31.6 x H31.6 x D38.5 mm W1.244 x H1.244 x D1.516 in DP2-40□ : W30 x H44.7 x D35 mm W1.181 x H1.760 x D1.378 in DP2-60□ : W46 x H69.5 x D43 mm W1.811 x H2.736 x D1.693 in DP2-80□ : W30 x H41 x D33.5 mm W1.181 x H1.614 x D1.319 in |
||||
| Accessories | DPX-02 (Hexagon-socket-head plug for pressure port): 1 pc. (Standard type only), Pressure unit label: 1 pc. |
||||
| Type | Positive pressure | ||||||
|---|---|---|---|---|---|---|---|
| 100 kPa type | 1 MPa type | ||||||
| Standard | Flat | IP67 | Standard | Flat | IP67 | ||
| Model No. | Asia | DP2- 21 | DP2- 41 | DP2- 61 | DP2- 22 | DP2- 42 | DP2- 62 |
| North America (Note 2) | DP2- 21F (-P) | DP2- 41N | DP2- 61N | DP2- 22F (-P) | DP2- 42N | DP2- 62N |
|
| Europe | - | DP2- 41E | DP2- 61E | - | DP2- 42E | DP2- 62E |
|
| Type of pressure | Gauge pressure | ||||||
| Rated pressure range | 0 to 100.0 kPa | 0 to 1.000 MPa | |||||
| Set pressure range | -5.0 to 100.0 kPa | -0.050 to 1.000 MPa | |||||
| Pressure withstandability | 490 kPa | 1.47 MPa | |||||
| Applicable fluid | Non-corrosive gas | ||||||
| Selectable units | kPa, kgf/cm2, bar, psi | MPa, kgf/cm2, bar, psi | |||||
| Supply voltage / Current consumption | 12 to 24 V DC +10 /-15 % Ripple P-P 10 % or less / 50 mA or less | ||||||
| Comparative outputs (Comparative Output 1 Comparative Output 2) |
NPN open-collector transistor ・Maximum sink current: 100 mA PNP open-collector transistor ・Maximum source current: 100 mA |
||||||
| Output modes | Equipped with 4 types of modes: hysteresis mode, window comparator mode, dual output mode, automatic sensitivity setting mode (selectable by key operation) | ||||||
| Response time | 2.5 ms or less | ||||||
| Analog voltage output | Output voltage: 1 to 5 V (over rated pressure range), Zero-point: within 1 V ± 5 % F.S. Span: within 4 V ± 5 % F.S., Linearity: within ±1 % F.S., Output impedance: 1 kΩ approx. |
||||||
| Display | 3 1/2 digit red LED display (Sampling rate: 4 times/sec. approx.) | ||||||
| Displayable pressure range | -5.0 to 100.0 kPa | -0.050 to 1.000 MPa | |||||
| Analog bar display | LED bar display in steps of 10 % F.S. approx. | ||||||
| Protection | Standard, Flat and Light weight types: IP40 (IEC), IP67 type: IP67 (IEC) |
||||||
| Ambient temperature | -10 to +50 ℃ +14 to +122 ℉ (No dew condensation or icing allowed), Storage: -10 to +60 ℃ +14 to +140 ℉ |
||||||
| Pressure port | Asia | Standard, Flat and IP67 types: Rc (PT) 1/8 female thread, Light weight type: M5 female thread |
|||||
| North America | Standard type: NPTF 1/8 female thread, Flat and IP67 types: NPT 1/8 female thread |
||||||
| Europe | Flat and IP67 types: G (PF) 1/8 female thread | ||||||
| Material | Front case: ABS, Rear case: PPS (glass fi ber reinforced), Display surface: Acrylic Pressure port attachment: Die-cast zinc alloy [Light weight type: POM (glass fi ber reinforced), pressure port is brass (nickel plated)] Front cover (IP67 type only): Polycarbonate |
||||||
| Net weight | Standard type: 95 g approx., Flat type: 120 g approx., IP67 type: 370 g approx., Light weight type: 70 g approx. |
||||||
| Dimensions | DP2-21□ / DP2-22□ : W31.6 x H31.6 x D38.5 mm W1.244 x H1.244 x D1.516 in DP2-41□ / DP2-42□ : W30 x H44.7 x D35 mm W1.181 x H1.760 x D1.378 in DP2-61□ / DP2-62□ : W46 x H69.5 x D43 mm W1.811 x H2.736 x D1.693 in |
||||||
| Accessories | DPX-02 (Hexagon-socket-head plug for pressure port): 1 pc. (Standard type only), Pressure unit label: 1 pc. |
||||||
Notes:
1) Where measurement conditions have not been specified precisely, the conditions used were an ambient temperature of +20 ℃ +68 ℉.
2) Model Nos. of North America standard type having the suffix "-P" are PNP output type.
