FX-11A Fiber Optic Sensors Specifications
Specifications for this product appear below.
Amplifier
| Model No. | FX-11A | |
|---|---|---|
| Supply voltage | 12 to 24 V DC ± 10 % Ripple P-P 10 % or less | |
| Current consumption | 35 mA or less | |
| Analog output | Analog voltage ・Output voltage: 1 to 5 V (proportional to incident light intensity) ・Output current: 5 mA or less ・Output impedance: 47 Ω ・Load resistance: 2 kΩ or more ・Temperature characteristics: 0.3 % F.S./℃ or less |
|
| Response time | Switchable either 1 ms or less, or 10 ms or less | |
| Incident beam indicator | Red LED (brightens up in proportion to analog output voltage) |
|
| Saturation indicator | Green LED (lights up when the analog output voltage reaches 5 V) |
|
| Sensitivity adjuster | 8-turn potentiometer with indicator | |
| Interference prevention function | Incorporated | |
| Ambient temperature | -10 to +55 ℃ +14 to +131 ℉ (No dew condensation or icing allowed), Storage: -20 to +70 ℃ -4 to +158 ℉ |
|
| Ambient humidity | 35 to 85 % RH, Storage: 35 to 85 % RH | |
| Ambient illuminance | Incandescent light: 1,000 lx at the light-receiving face | |
| Voltage withstandability | 1,000 V AC for one min. between all supply terminals connected together and enclosure (Note 2) | |
| Insulation resistance | 20 MΩ, or more, with 250 V DC megger between all supply terminals connected together and enclosure (Note 2) | |
| Vibration resistance | 10 to 150 Hz frequency, 0.75 mm 0.030 in amplitude in X, Y and Z directions for two hours each | |
| Shock resistance | 100 m/s2 acceleration (10 G approx.) in X, Y and Z directions for five times each | |
| Emitting element | Red LED (Peak emission wavelength: 660 nm 0.026 mil, modulated) |
|
| Material | Enclosure: Heat-resistant ABS, Case cover: Polycarbonate, Fiber lock lever: PES | |
| Cable | 0.2 mm2 4-core cabtyre cable, 2 m 6.562 ft long | |
| Cable extension | Extension up to total 100 m 328.084 ft is possible with 0.3 mm2, or more, cable. (Note 3) | |
| Weight | Net weight: 60 g approx., Gross weight: 100 g approx. | |
| Accessories | MS-DIN-2 (Amplifier mounting bracket): 1 pc., Adjusting screwdriver: 1 pc. | |
Notes:
1) Where measurement conditions have not been specified precisely, the conditions used were an ambient temperature of +23 ℃ +73.4 ℉.
2) The voltage withstandability and the insulation resistance values given in the above table are for the amplifier only.
3) Take care that the output voltage drops when the cable is extended.
