LC2H Counters Dimensions
Dimensions/model drawings for this product appear below. Units are usually notated in millimeters (mm) and in inches (in) (if provided).
LC2H Total Electronic Counters - Panel Mounting Type
1. One-touch installation type
External dimensions
| General tolerance : | ±1.0mm |
| ±0.39in |
Panel installation diagram
Note) When installing to a 4.5mm/ .177 inch thick panel, remove the rubber spacer first.
When installing the one-touch installation type model, make sure that the installation spring does not pinch the rubber gasket.
To prevent the installation spring from pinching the rubber gasket:
| 1. | Set the rubber gasket on both ends of the installation spring (left and right). |
|---|---|
| 2. | Confirm that the installation spring is not pinching the rubber gasket, and then insert and fix the installation spring in place from the rear of the timer unit. |
2. Installation frame type
External dimensions
| General tolerance: ±1.0mm ±.039in |
Panel mounting diagram
Panel cut-out dimensions
The standard panel cut-out is shown below.
Use the mounting frame (ATH3803) and the rubber packing (ATH3804). (Only installation frame type.)
For connected installation (sealed installation)
(Only installation frame type.)
| Notes) | 1. Suitable installation panel thickness is 1 to 4.5 mm/ .039 to .177 inch. |
|---|---|
| 2. Waterproofing will be lost when installing repeatedly (sealed installation). |
LC2H Total Electronic Counters - PC Board Mounting Type
External dimensions
|
General tolerance : |
±1.0mm |
| ±0.39in |
PC board pattern (BOTTOM VIEW)
LC2H Preset Counters
External dimensions
| General tolerance: ±1.0mm ±.039in |
When installing the one-touch installation type model, make sure that the installation spring does not pinch the rubber gasket.
To prevent the installation spring from pinching the rubber gasket:
| 1. | Set the rubber gasket on both ends of the installation spring (left and right). |
|---|---|
| 2. | Confirm that the installation spring is not pinching the rubber gasket, and then insert and fix the installation spring in place from the rear of the timer unit. |
Panel cut-out dimensions
The standard panel cut-out is shown below.
Use the mounting frame (ATH3803) and the rubber packing (ATH3804). (Only installation frame type.)
When installing repeatedly (sealed installation)
(Only installation frame type)
| Notes) | 1. Suitable installation panel thickness is 1 to 4.5 mm/ .039 to .177 inch. |
|---|---|
| 2. Waterproofing will be lost when installing repeatedly (sealed installation). |
